Description

Cable break at the output SPD_SIG

Effects on the driving operation

The output signal can no longer change in relation to the output speed. The signal is evaluated by external control units, e.g. the door control may be affected.

Possible causes

Cable and/or plug connection defective.

Connector pin assignment of the transmission control unit

Pin	Stecker A	Stecker B	Stecker C	Stecker D
1	SHIELD	EK	FLEXI-1	-BATT
2	TIM+	DK	---	IGN
3	TIM-	SK	FLEXI-3	FLEXI-11
4	N1+	RBK	FLEXI-4	K-LINE
5	N1-	TB	FLEXI-5	CAN1-H
6	N2+	---	FLEXI-6	CAN1-H
7	N2-	RBG	FLEXI-7	CAN-SHLD
8	N3+	PB	FLEXI-8	CAN1-L
9	N3-	WR	FLEXI-9	CAN1-L
10	---	WP	FLEXI-10	CAN2-H
11	---	---	FLEXO-2H	CAN2-H
12	EKM	FLEXI-12	FLEXO-4H	CAN2-L
13	DKM	S-GND	FLEXO-3H	CAN2-L
14	SKM	OIL-LVL	FLEXO-5L	CAN1-R
15	PBM	T-SUMP	---	---
16	TBM	---	---	FLEXO-1L
17	RBKM	T-CONV	---	CAN2-R
18	MVM-GND	MV-GND	---	+BATT

Place of action

No description available.

Instruction

Check plug connections and cables.

Setting conditions of the event

No description available.

Test conditions of the event

No description available.

Final function check

If the defective component cannot be clearly identified, you should try to reproduce the fault:

• Reinstall the component in the vehicle.
• Test the function.

After the fault has been eliminated, the following steps have to be carried out:

• Conduct a test drive with function check.
• Read out the fault memory.
• Check the transmission for leaks.
• Perform a final visual inspection.

These steps are necessary to ensure the entire vehicle functions.

See also:

		Troubleshooting for cable break
		Aftersales service index