Description

Dataset error in the signal assignment to an input of the E300.

Effects on the driving operation

ANS is not activated in bus stop mode.

Possible causes

The configuration of the dataset value FLEXI_BSB_IN_SETTING_ is incorrect.

Connector pin assignment of the transmission control unit

Pin	Stecker A	Stecker B	Stecker C	Stecker D
1	SHIELD	EK	FLEXI-1	-BATT
2	TIM+	DK	---	IGN
3	TIM-	SK	FLEXI-3	FLEXI-11
4	N1+	RBK	FLEXI-4	K-LINE
5	N1-	TB	FLEXI-5	CAN1-H
6	N2+	---	FLEXI-6	CAN1-H
7	N2-	RBG	FLEXI-7	CAN-SHLD
8	N3+	PB	FLEXI-8	CAN1-L
9	N3-	WR	FLEXI-9	CAN1-L
10	---	WP	FLEXI-10	CAN2-H
11	---	---	FLEXO-2H	CAN2-H
12	EKM	FLEXI-12	FLEXO-4H	CAN2-L
13	DKM	S-GND	FLEXO-3H	CAN2-L
14	SKM	OIL-LVL	FLEXO-5L	CAN1-R
15	PBM	T-SUMP	---	---
16	TBM	---	---	FLEXO-1L
17	RBKM	T-CONV	---	CAN2-R
18	MVM-GND	MV-GND	---	+BATT

Place of action

No description available.

Instruction

Load correct dataset.

Setting conditions of the event

No description available.

Test conditions of the event

No description available.

Final function check

If the defective component cannot be clearly identified, you should try to reproduce the fault:

• Reinstall the component in the vehicle.
• Test the function.

After the fault has been eliminated, the following steps have to be carried out:

• Conduct a test drive with function check.
• Read out the fault memory.
• Check the transmission for leaks.
• Perform a final visual inspection.

These steps are necessary to ensure the entire vehicle functions.

See also:

		Aftersales service index