Description

Failure opening the ground connection of the solenoid valves

Effects on the driving operation

E300 goes into the 'forced neutral' mode.

Possible causes

Short-circuit to ground of the SV ground cable.

Safety switch defective.

Connector pin assignment of transmission control unit

Pin	Stecker A	Stecker B	Stecker C	Stecker D
1	SHIELD	EK	FLEXI-1	-BATT
2	TIM+	DK	---	IGN
3	TIM-	SK	FLEXI-3	FLEXI-11
4	N1+	RBK	FLEXI-4	K-LINE
5	N1-	TB	FLEXI-5	CAN1-H
6	N2+	---	FLEXI-6	CAN1-H
7	N2-	RBG	FLEXI-7	CAN-SHLD
8	N3+	PB	FLEXI-8	CAN1-L
9	N3-	WR	FLEXI-9	CAN1-L
10	---	WP	FLEXI-10	CAN2-H
11	---	---	FLEXO-2H	CAN2-H
12	EKM	FLEXI-12	FLEXO-4H	CAN2-L
13	DKM	S-GND	FLEXO-3H	CAN2-L
14	SKM	OIL-LVL	FLEXO-5L	CAN1-R
15	PBM	T-SUMP	---	---
16	TBM	---	---	FLEXO-1L
17	RBKM	T-CONV	---	CAN2-R
18	MVM-GND	MV-GND	---	+BATT

Pin assignment of transmission connector

Pin	Name	Pin	Name	Pin	Name
1	S-GND	14	RBK	27	EKM
2	MV-GND	15	RBG	28	PBM
3	MV-GND	16	TB	29	RBKM
4	---	17	WR	30	TBM
5	T-CONV	18	---	31	MVM-GND
6	T-SUMP	19	---	32	N1+
7	OIL-LVL	20	---	33	N1-
8	P-DIFF	21	TIM-	34	N2+
9	SK	22	TIM+	35	N2-
10	DK	23	---	36	N3+
11	EK	24	SHIELD	37	N3-
12	PB	25	SKM
13	WP	26	DKM

Place of action

No description available.

Troubleshooting

Check whether the ground wire of the solenoid valves is short-circuited to the vehicle ground.

Only if this measure remains unsuccessful: Replace control unit!

Setting conditions of the event

No description available.

Test conditions of the event

No description available.

Final function check

If the defective component cannot be clearly identified, you should try to reproduce the fault:

• Reinstall the component in the vehicle.
• Test the function.

After the fault has been eliminated, the following steps have to be carried out:

• Conduct a test drive with function check.
• Read out the fault memory.
• Check the transmission for leaks.
• Perform a final visual inspection.

These steps are necessary to ensure the entire vehicle functions.

See also:

		Aftersales service index